B&B Electronics 00-00234 - Manual - Manual (Page 7)

Installation guide
Before you can install the Ranger 2104, you need to prepare your site.
1. Determine where the computer is to be located and set up the computer.
2. Determine where you want to locate the USB device(s).
3. If you are using surface cabling, the Ranger 2104 supports a maximum distance of 100m.
OR
If you are using premise cabling, ensure CAT 5 cabling is installed between the two
locations, with CAT 5 information outlets located near both the computer and the USB
device(s).
Installing the LEX unit
1. Place the LEX unit near the computer.
2. Plug the USB Type A connector on the LEX into a USB port on the computer.
Installing the REX unit
1. Place the REX unit near the USB device(s).
2. Plug the power adapter into a suitable AC outlet.
3. Connect the power adapter to the REX unit.
Use only the AC adapter supplied with the Ranger. Use of substitute adapters may cause permanent
damage to the system and will void the warranty.
6
USB extension up to 100m CAT 5 (or better) cable