B&B Electronics 00-00234 - Manual - Manual (Page 4)

Introduction
The instructions in this guide assume a general knowledge of computer installation procedures, familiarity
with cabling requirements, and some understanding of USB devices.
NOTE: Notes provide additional information that could be useful.
CAUTION: Cautions provide important information about an operational requirement.
Ranger 2104 Product Contents
Your Ranger 2104 is packaged with:
• Ranger 2104 Quickstart Guide - located on the outer box sleeve
• LEX unit (Local Extender)
• REX unit (Remote Extender)
• REX AC power adapter (1)
Warranty card
•
An additional AC power adapter may be purchased for the LEX unit in the event that your USB port can not supply
the required 500mA current. Please contact an Icron Sales representative for further details (See Page 13)
Requirements
To complete the installation, you will also require the following items that are not included with the product:
• USB 1.1 or 2.0 compatible computer (host computer) with a USB compliant operating system
• USB 1.1 or 2.0 compatible device
• CAT 5 Unshielded Twisted Pair (UTP) cable with two RJ45 connectors (if using surface cabling),
OR, CAT 5 cabling with two information outlets and two CAT 5 patch cords with RJ45 connectors (if
using premise cabling)
All references to CAT 5 cable in this document represent the minimum requirement. Category 6 or better or STP cable
may be substituted.
About the Ranger 2104
The Ranger 2104 incorporates Icron’s patented ExtremeUSB® technology, enabling users to extend beyond
the standard 5m cable limit for USB peripheral devices. With the Ranger 2104, USB devices can be located up
to 100 meters from the computer.
The Ranger is composed of two individual units; the LEX unit and the REX unit.
note
note
note
3