B&B Electronics 850-18510 - Manual - Manual (Page 4)

1
About the IE-iMcV-Gigabit TX/SFP
NOTE
Unless noted otherwise, all references to the IE-iMcV-Gigabit TX/SFP in this manual are
also applicable to the iMcV-Gigabit TX/FX.
The SNMP manageable IE-iMcV-Gigabit TX/SFP Module provides a single
conversion between 1000 Base-T twisted pair and 1000 Base-SX/LX fiber. Each
IE-iMcV-Gigabit TX/SFP includes one RJ-45 connector and one pair of SC fiber
optic connectors, and/or an SFP port, which can support any fiber type; dual
strand available in LC connectors, and Single Strand Fiber SFPs available in SC
connectors. IE-iMcV-Gigabit TX/SFP Modules install into any modular, SNMP
manageable iMediaChassis, as well as the MediaChassis series, which is
unmanaged. The IE-iMcV-Gigabit TX/SFP offers an extended temperature range
of -40C to +85C; when installed in an IE-MediaChassis/1 or 2, available in AC and
DC, the module can be installed in challenging heat or cold-related
environments.
NOTE
All IE-iMcV-Gigabit TX/SFP Modules, including 1300 nm multi-mode and 1310 nm single-
mode (TX/LX), 850 nm multi-mode fiber (TX/SX) and single-strand versions (TX/SSLX) will
be referred to as IE-iMcV-Gigabit TX/SFP throughout this guide except where differences
need to be indicated.
Installing an iMcV-Module
iMcV-Modules install in IMC Networks’ SNMP manageable iMediaChassis series
or in any MediaChassis.
To install an iMcV-Module:
1. Remove the blank bracket covering the slot where the module is to be
installed by removing the screws on the outside edges of the bracket.
2. Slide the iMcV-Module into the chassis, via the cardguides, until the module
is seated securely in the connector.
3. Secure the module to the chassis by tightening the captive screw.
4. Save any “blanks” removed during installation for future use if the
configuration requirements change.