B&B Electronics 850-18610 - Manual User Manual
Page 5
2
Installing an iMcV-Modules
The iMcV-Modules install in B&B Electronics’ SNMP manageable iMediaChassis
series or in any MediaChassis.
NOTE
All modules are hot-swappable.
To install an iMcV-Module:
1. Remove the blank bracket covering the slot where the module is to be
installed by removing the screws on the outside edges of the bracket.
2. Slide the iMcV-Modules into the chassis, via the cardguides, until the module
is seated securely in the connector.
3. Secure the module to the chassis by tightening the captive screw.
4. Save any “blanks” removed during installation for future use if the
configuration requirements change.
Managed Modules
To manage one or more IE-iMcV-2xLIM, TX/SFP(s), an SNMP agent must be
present in the chassis. To configure Managed Modules, install the module first,
and then configure using the management software.
Configuration Control and SNMP Management
Some iMcV-Modules offer Configuration Control; labels on the front faceplate
will identify if the iMcV-module has Configuration Control. Configuration Control
has been implemented to assist the end user for the following:
Any module, iMcV-module or SNMP Management Module, can be
changed under power with out losing any configuration.
The Management Module can be added to a chassis without losing any
configuration the modules have been set to.
The Management Module will not be subjected to a “Mission Critical”
condition. If the Management module is removed or fails, the iMcV-
modules will not experience an interruption in service.
Configuration Control was created to solve the following issues: