Rainbow Electronics GM862-GPS - Manual (Page 78)

Easy Script in Python
80000ST10020a Rev.8 - 01/10/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 78 of 100
After 10 seconds you should see the script starting and the debug info appearing on the
terminal emulator window.
• If an ERROR messages appears in the Virtual Port #1,2,3,4 boxes, close any application
controlling the serial ports and then restart the Telit CMUX application. If this procedure is not
sufficient to avoid ERROR message, reset the PC, run again Telit Serial Port Mux with the
same settings and repeat the procedure as described above.
• If you need to debug the same Python application again, then:
• Disconnect the terminal emulator application (eg. Hyper Terminal) from the Virtual
Port#4 (in this case COM10)
• “Status:” of the Virtual Port#4 in the Telit Serial Port Mux window, should change
from Opened to Idle
• Switch off the module
• Connect the terminal emulator application to Virtual Port#4 (in this case COM10)
• “Status:” of the Virtual Port#4 in the Telit Serial Port Mux window 26 , should change
from Idle to Opened
• Switch on the module and wait for the “Status:” of the Modem Port in the Telit Serial
Port Mux window to go connected
26 If the Telit Serial Port Mux application seems to be freezed, please consider that it becomes active after the
module is switched on.