Rainbow Electronics GM862-GPS - Manual (Page 72)

Easy Script in Python
80000ST10020a Rev.8 - 01/10/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 72 of 100
• Then select a Virtual COM, different from the other COM ports preferably (“COM8” in the
figure), and associate to it the first SSC device that appearing in the list (“Data Module
EVK2A” in the figure),
• the following figure should appear:
NOTE: If the PC uses the EVK2 RS232 upper port (ASC0) to send AT commands, remember
to put all jumpers to set RS232 mode. This will not affect reading of Python debug data from
the USB port