TC Electronic M350 - Manual (Page 33)

APPENDIX –
MIDI CC & RESET & BULK DUMP
31
MIDI Bulk Dump
By performing a MIDI bulk dump, you can
dump all presets to an external MIDI device
(e.g. a sequencer) for backup purposes.
• Press and hold the PRESET ON/OFF key for
approximately 2.5 seconds.
• Use the ARROW UP/DOWN keys to select
Bulk Dump mode.
The display will show:
• Set the receiving device to its MIDI Bulk
Receive Mode. Please refer to the user
manual of the receiving device if you do not
know how to do this. With a standard MIDI
sequencer, arming a MIDI track for recording
should be sufficient.
• Press LOAD once, and the MIDI Bulk Dump
will be sent.
The M350 is always ready to receive a
MIDI bulk dump unless its MIDI Receive
Channel is set to “OF”.
Reset Procedure
If you would like to do a complete reset of the
M350 and return to factory settings, follow this
procedure:
• Power the M350 down by disconnecting the
power cord.
• Press and hold TAP while reconnecting
power. The display will show a flashing “R”.
• Press Load to reset.
• Switch the unit off and on again.
The unit is now reset.
Be aware that all User presets will be
lost when performing a factory reset!
You can control the parameters listed below by
sending MIDI Control Changes from an external
MIDI device.
Parameter Control Change
number:
In Level 12
Mix 13
Effect Bal. 14
Digi. In 15
Bypass 81
Delay Type 50
Delay/Effects. Off 82
Timing 16
Tap 80
Feedback 17
Rev. Type 51
Rev. Off 83
PreDelay 18
Decay 19
Color 20