TC Electronic M350 - Manual (Page 21)

19
THE DELAY-EFFECTS ENGINE
TIMING knob – De-Ess and Compression:
For the De-Ess algorithm the TIMING knob
controls the Amount parameter.
For the Compressor algorithm the TIMING knob
controls the Drive parameter.
The higher you set the TIMING knob, the
harder the Compressor is hit. Or you could say
that the threshold is lowered and make-up gain
is applied at the same time as level
compensation.
TIMING knob – Chorus, Flanger, Phaser and
Tremolo:
Increases/decreases the tempo.
Remember that the default setting suggested
by TC Electronic is achieved by setting the
knob in 12 o’clock.
FEEDBACK/DEPTH
– FREQUENCY/RATIO knob
This knob changes functionality with the
selected algorithms.
The knob controls the Feedback parameter in:
All Delays
The knob controls the Depth parameter in:
Chorus
Flanger
Phaser
Tremolo
The knob controls the Frequency parameter in:
De-Ess
The knob controls the Ratio parameter in :
Compressor
For further details on these parameters,
please read the Delay/Effects chapter on
pages 24-27.