Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter - Manual (Page 95)

9035-OM (V4.4) 9035 PRODUCT MANUAL 3-51
Operating Instructions
9035 Function Submenu List and Descriptions
Figure 3-7 Dolby
®
E Processing Example (Sheet 2 of 2)
Using the Status display in the Audio Input Controls function, AES Pair 1 shows locked Dolby ® E data.
DOLBYEX_AIC.PNG
Metadata Serial Out Source = Dolby Decoder selection also routes the
decoder metadata to the DOLBY META RS-485 output.
DOLBYEX_DD.PNG
In this example, since the
decoder displays a “5.1+2”
configuration, the eight
channels comprising this
configuration can be
embedded using eight spare
embedded channels.
As such, the eight total
decoded channels produced
(Dolby Ch 1 thru Dolby Ch 6,
and Dolby Mix 1 / Dolby Mix 2
corresponding to L, R, C, LFE,
LS, RS, and Lo/Ro monitors)
can be respectively routed to
embedded channels 9 thru 16
as shown to the left using the
Embedded Audio Group 3/4
function.
(Note that decoder channels 7
and 8 are not used in this
format.)
DOLBYEX_EAG12.PNG
AES Pair 1 is then selected as the Dolby Decoder Input Select source. The
Bitstream Format and Dolby E Program Configuration displays also show
this signal as Dolby
®
E; 5.1+2
Metadata Embedding = On allows decoder metadata embedding into the
SDI stream (on line 13 as shown).
Metadata Embedded Source = Dolby Decoder selects decoder metadata
as the source for embedded metadata.