Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter - Manual (Page 54)

3
9035 Function Submenu List and Descriptions
3-10 9035 PRODUCT MANUAL 9035-OM (V4.4)
Table 3-2 9035 Function Submenu List
Video Signal Controls
This function sets the 9035 video signal input type and
preference and priority
• Input Video Preference Sets the input video preference and priority for SDI and analog video
inputs as follows:
• SDI Only: Sets the video input to accept only SDI input. Blocks all
analog video inputs.
• SDI over Analog: Sets the video input to accept SDI over
composite/component analog video inputs. Blocks analog video
inputs when valid signal is received by SDI input.
• Analog Only: Sets the video input to accept only composite and/or
component analog video inputs. Blocks SDI input.
• Analog over SDI: Sets the video input to accept composite/
component analog over SDI video inputs. Blocks SDI input when
valid signal is received by composite and/or component analog
video inputs.
• HD Analog Input Type When receiving analog video input, sets the 9035 HD input video type to
accept received input signal from choices shown.
Note: Input type must be appropriately set for the 9035 to correctly
process the received input.
• SD Analog Input Type When receiving analog video input, sets the 9035 SD input video type to
accept received input signal from choices shown.
Note: Input format must be appropriately set for the 9035 to correctly
lock to the input.
• NTSC Contains This setting tells the 9035 how much setup (pedestal) needs to
be removed from an NTSC-formatted input.
• 0 IRE of Setup: No setup removed.
• 7.5 IRE of Setup: Removes 7.5 IRE of setup. This is typically
preferred when analog signals containing 7.5 IRE pedestal are
converted to SDI.