Cobalt Digital COMPASS 9085 Loudness Processor - Manual (Page 37)

9085-OM (V4.3) 9085 PRODUCT MANUAL 2-11
Installation and Setup
Setting Up 9085 Network Remote Control
Setting Up 9085 Network Remote Control
Perform remote control setup in accordance with Cobalt ® reference guide
“Remote Control User Guide (PN 9000RCS-RM)”.
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide Remote
Control User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™. (Cobalt
® OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the
Support>Documents>Reference Guides link at www.cobaltdigital.com
and then select DashBoard Remote Control Setup Guide as a download, or
contact Cobalt
® as listed in Contact Cobalt Digital Inc. (p. 1-22).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
RM20-9085-E-DIN-HDBNC High-density rear modules provides the following
connections:
• HD/SD-SDI coaxial input (SDI IN)
• Eight AES coaxial inputs (AES IN 1 thru AES IN 8)
• Eight AES coaxial outputs (AES OUT 1 thru
AES OUT 8)
• One HD/SD-SDI reclocked input copy
(RCK OUT 1)
• Two buffered SDI coaxial outputs (SDI OUT)
Note: Available equipped with High-Density BNC
(HDBNC) or DIN1.0/2.3 connectors as:
RM20-9085-E-HDBNC or RM20-9085-E-DIN,
respectively.
Table 2-1 9085 Rear I/O Modules — continued
9085 Rear I/O Module Description