Moog Music 500 Series Analog Delay - Manual (Page 16)

16
CIRCUIT CONFIGURATION
The figure below is a simplified block diagram of the Analog Delay.
MIDI CONTROL OF THE ANALOG DELAY
The following section explains the MIDI implementation of the Analog De-
lay. For information about what MIDI is and how it works, you can go to the
following webpage for tutorials: www.midi.org/aboutmidi/tutorials.php
MIDI CHANNEL
The default MIDI Channel for the Analog Delay is Channel 1. To change this,
send the MIDI channel you wish to change to CC 119 on the existing chan-
nel. The MIDI channel is the value sent. +1 i.e. to set the Delay to receive on
MIDI channel 2 send a value of 1 to CC119. The
MIDI LED will flash ORANGE
indicating that the message has been received. The Delay will now only
receive MIDI messages on that channel. The current MIDI Input channel is
stored in memory on power down.
Note: MIDI Clock and System Exclusive messages are NOT Channel Mode
messages, and are received by the Analog Delay regardless of the current
MIDI Input Channel.