Daystar KJ09137BK - Manual (Page 5)

9
12. Raise up the rear axle to reconnect the shocks and install the rear
sway bar and brake line bracket.
13. For 1 3/4 lift you will need to install the sway bar drop bracket
Between the sway bar mount and the frame. Install the 2 sleeves
into the drop bracket and place between the frame and sway bar,
Using the supplied longer bolts and Loctite.
14. Install the rear wheels and torque lug nuts to 85 ft.lbs.. And
Lower back on ground. Remove all jacks and jack stands from
Under vehicle.
15. You will need to have the vehicle realigned after install is complete.
16. With vehicle on ground center steering wheel.
Sleeve
Drop bracket
Spacer
Isolator pad
For KJ09137
10
Daystar® Lifetime GoEverywhere Limited Warranty
Your Daystar® Comfort Ride or Budget Boost leveling kit is covered by the
following Go Everywhere Lifetime Limited Warranty provided exclusively
by Daystar Products International, Inc., 841 South 71st Ave., Phoenix, AZ
85043 (“Daystar”).
!Caution: Have an alignment professional check and ad-
just the alignment to factory specifications.
17. With the vehicle on the ground cycle the steering wheel
Side to side and inspect suspension components, brake
Lines and tires to ensure there are not any clearance
18. Issues. Bounce the suspension to assure operates freely,
Brake lines retain proper slack at full extension and
That they remain clear from spring or other obstructions.
19. Install “Warning to Driver” decal on the vehicle’s sun
visor or dash. The decal must be placed in a conspicuous
location. Anyone that operates the vehicle must be made
aware of the changes made.
20. After 25 miles of driving re-torque the lug nuts to 120
ft.lbs..
21. After 500 miles of driving re-torque all of the hardware