Daystar KJ09137BK - Manual (Page 4)

7
5. With the coil spring removed install new lift spacer on top of stock
Spring with factory isolator pad on top of spacer.
NOTICE: do not over extend or stretch brake line
6. Install the coil spring on the driver side first then the passenger side
Using jack raise up axel and reconnect shocks, sway bar end link and
ABS (Anti Lock Brake ) line. Check positioning of parts and torque to
Factory specs. Install the front wheels and torque lug nuts to 85 ft.lb.
Spacer
Isolator
Reattach
Reattach
8
7.
Place the wheel chock at the front wheels and jack up the rear sus-
pension and support the vehicle at the frame and remove the rear
tires.
8. With the jack under the rear axle, jack up it up so you can disconnect
the rear shocks and rear sway bar at the frame and the bracket that
holds the brake line to the frame.
NOTICE: do not overextend or stretch brake line.
10. Lower the axle down to remove the coil springs.
11. With the coil removed, install the rear lift spacer on top of the stock
Spring with factory isolator pad on top of spacer.
Sway bar
Shock
Spring removed