Daystar KJ04508BK User Manual
Page 2
Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system. In addition to
these instruction , professional knowledge of disassemble/reassembly proce-
dures as well as post instructions checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity
and/or operating of the vehicle.
Please read all the instructions before beginning the installation. Check the kit
hardware against the parts list. Be sure you have all the needed parts and un-
derstand where they go. If anything is missing , do not proceed with the instal-
lation, call Daystar Products to obtain needed items.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly rec-
ommend , because of rollover possibility, that Seat belts and shoulder harness be
worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/
heavier tires and wheels are used. Take this into consideration while driving,
Also , speedometer recalibration is necessary when larger tires are installed.
Do no add, alter, or fabricate any factory or after-market parts which increase
vehicle height over the intended height of the Daystar Product purchased. Mix-
ing component brands, lifts, and/or combining body lift with suspension lift
voids all warranties. Daystar makes no claims regarding lifting devices and ex-
cludes any and all implied claims. We will not be responsible for any products
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to diver”
decal installed on the sun visor or dash. The decal is to act a constant reminder for
whoever is operating the vehicle of its unique handling characteristics. INSTALL-
ING DEALER— Its is your responsibility to install the warning decal and forward
these instructions on too the vehicle owner for review and to be kept in the vehicle
for service life.
After installation occurs, a qualified alignment facility is required to align the ve-
hicle to factory specs.
BODY MOUNT LOCATION