Electronics FC-24 - Manual (Page 10)

10
10. MAINTENANCE
There is no maintenance required for the FC-24 controller.
Power: 24 Vdc @ 0.5 Amp
Inputs: 0-5 A ac from current transformer loop
Remote analog setpoint 0-10 Vdc
Enable input 24 Vdc
Alarm reset 24 Vdc
Outputs: Servo output signal 0-10 Vdc
Recorder Analog output 0-10 Vdc
Alarm relay contacts (rated at 120 Vac @ 0.5 Amp)
Enable output signal 24 Vdc
Weight: 2.2 pounds / 1 Kg
Display range: 0-1999
Decimal Points: 1000, 100.0, 10.00
Alarm Bandwidth: 0-50% of full scale or of set point
Alarm Delay: 0-10 seconds
Enable Delay: 0-10 seconds
1 0 Vdc, Common 0 Vdc, Common 11
2
Remote Setpoint (0-10 Vdc) Alarm Reset (24 Vdc)
12
3
0 Vdc, Common Alarm High Relay Contact
13
4
Enable Input (24 Vdc) Alarm Common Relay Contact
14
5
0 Vdc, Common Alarm Low Relay Contact
15
6 Process Input (0-10 Vdc) Flow “OK” Relay Contact 16
7 Process Input (0- 0.5 Vac) 0 Vdc, Common 17
8 Servo Output (0-10 Vdc) Recorder Output (0-10 Vdc) 18
9 Enable Output (24 Vdc) 24 Vdc Power 19
10
0 Vdc, Common 0 Vdc, Common
20