Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 4)

4 PNEG-1445 6", 8", 10" and 12" Custom Augers
1. Introduction
General Information
READ THIS MANUAL carefully to learn how to properly use and install equipment. Failure to do so could
result in personal injury or equipment damage.
INSPECT the shipment immediately upon arrival. The customer is responsible for ensuring that all
quantities are correct. The customer should report and note any damage or shortage on the bill of
lading to justify their claim to the transport company.
THIS MANUAL SHOULD BE CONSIDERED a permanent part of your equipment and should be easily
accessible when needed.
This warranty provides you the assurance that the company will back its products when defects appear
within the warranty period. In some circumstances, the company also provides field improvements, often
without charge to the customer, even if the product is out of warranty. Should the equipment be abused,
or modified to change its performance beyond the factory specifications, the warranty will become void
and field improvements may be denied.
Receiving Merchandise and Filing Claims
INSPECT the shipment immediately upon arrival. The customer is responsible for ensuring that all
quantities are correct. Report any damage or shortages by recording a detailed description on the bill of
lading to justify the customer’s claim from the transport firm. When receiving merchandise, it is important
to check both the quantity of parts and their descriptions with the packing list enclosed within each
package. All claims for freight damage or shortage must be made by the consignee within ten (10) days
from the date of the occurrence of freight damage. The consignee should accept the shipment after
noting the damage or loss.
Capacity
A. The capacities may vary greatly under varying conditions. The following factors play a role in the
performance of the auger:
B. For example, a twenty-five percent (25%) moisture could cut capacity by as much as 40% under
some conditions.
• Speed • Amounts of foreign matter
• Angle of operation • Different materials
• Moisture content • Methods of feeding