Installing the intake guard (continued), Installing intake shaft – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 User Manual
Page 27
4. Assembly
PNEG-1445 6", 8", 10" and 12" Custom Augers
27
Installing the Intake Guard (Continued)
4. Place intake guard half band above the lower half band on the intake guard and attach using proper
hex bolts and nylock nuts.
Figure 4Y
Assembling the Inlet Hopper with Bearings for all 6", 8", 10" and
12" Custom Augers
Installing Intake Shaft
1. Begin by assembling the intake shaft to the flight using the required grade 8 bolts and stover nuts.
and
Figure 4Z
6" Units require 20". It is necessary to field cut auger tube lengths to accommodate required
exposure. Butt the auger tube to the unloader tube and attach using a connecting band.
IMPORTANT: Auger stub shaft supplied is designed to fit GSI 6" bulk tank augers. If using a
different auger supplier it may be necessary to modify or fabricate a stub shaft for
the unloader bearing.
Flight Hardware
6"
3/8"-16 x 2" Grade 8 Hex Bolts
8"
7/16"-14 x 3" Grade 8 Hex Bolts
10"
1/2"-13 x 3-1/2" Grade 8 Hex Bolts
(
for bolt sizes.)