Installing the motor mount plate (continued), Installing the belt guard brackets – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 User Manual

Page 16

16 PNEG-1445 6", 8", 10" and 12" Custom Augers

4. Assembly

Installing the Motor Mount Plate (Continued)

4. When the pivot rod begins to extend through the pivot tube install the spacers, BETWEEN the back

plate and the inner face of the motor mount plate.

NOTE: The number of spacers will vary between each size of unloader.

Figure 4F

Installing the Belt Guard Brackets

1. Align the holes on the bearing plate with the slots on the belt guard mounting brackets.

2. Secure the brackets with proper bolts, flat washers, and serrated flange nuts.

and

NOTE: DO NOT tighten the bolts completely. The brackets will need to be rotated to align the slot

in the belt guard with the shafts on the motor and flight.

Figure 4G

Belt Guard Bracket Bolts

6" and 8"

5/16"-18 x 1" Bolt

10" and 12"

3/8"-16 x 1-1/4" Bolt

(

for bolt sizes.)