Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 36)

36 PNEG-1445 6", 8", 10" and 12" Custom Augers
8. Shut Down
Normal Shut Down
1. Make certain unloading tubes are empty before stopping the unit.
2. Disconnect and lock out the power source before leaving the work area.
Emergency Shut Down
1. Know how to shut down the auger in case of an emergency.
2. Disconnect and lock out the power source.
3. Close bin well control gates.
4. Clear out as much grain from the auger and hopper as possible.
5. Reconnect and unlock the power source.
6. Gradually clear the auger until there is no grain or obstruction.
Lock Out
1. Always stop and disconnect the power source whenever the operator must leave the work area or
for maintenance of the machinery.
2. Make sure equipment is locked out and that the machinery cannot be started while the operator is
not in the work area.
Storage Preparation
1. Close all wells to discharge tube.
2. Be sure the unload tube is empty.
3. Make sure power source is disconnected and locked out.
4. Check to see that all fasteners are secure.
Never restart when under a full load. Starting unit under load may result in
damage to the machine. Such damage is considered abuse of the equipment.
Use the type of main power disconnect switch that is capable of being locked
only in the OFF position.