Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 13)

PNEG-1445 6", 8", 10" and 12" Custom Augers 13
4. Assembly
Motor Mount Installation Instructions for all 6", 8", 10" and 12"
Custom Augers
Installing Drive Shaft
1. Insert the drive shaft into the opposite end of flight with keyway facing outward. Align the holes in
the shaft and secure with grade 8 bolts and stover nuts. (See Chart below and Figure 4A.)
Figure 4A
Mounting Bearing to Bearing Plate
1. Align bolt holes on bearing flange with bolt holes on bearing plate.
2. Secure bearing to bearing plate using appropriate bolts, lock washers, and nuts. (See Chart below
and Figure 4B on Page 14.)
Flight Hardware
6" 3/8"-16 x 2" Grade 8 Hex Bolts
8" 7/16"-14 x 3" Grade 8 Hex Bolts
10" 1/2"-13 x 3-1/2" Grade 8 Hex Bolts
12" 5/8"-11 x 4" Grade 8 Hex Bolts
Bearing Bolts
6" 7/16"-14 x 1-1/2" Bolt
8" and 10" 1/2"-13 x 1-1/2" Bolt
12" 5/8"-11 x 2" Bolt
( See Chart above for bolt sizes.)