Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1295 - Manual (Page 39)

PNEG-1295 16" - 36" Platform 39
9. 6 X 6 DISTRIBUTOR PLATFORM
Support Channels & Knee Braces
With clamps fastened securely to the trunk, attach the platform support channels to the middle
clamp, use 1/2" hardware with this assembly. The knee braces will attach in the upper set of
holes on side of support channel and to the lower clamp. Before tightening hardware the support
channels must be perpendicular to the trunk, now tighten all hardware.The toeboards will not be
centered on trunking but should be offset to the ladder side. The platform is designed to work for
either side of trunking access.
Figure 9B