beautypg.com

Installing the belt guard – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 User Manual

Page 22

background image

22 PNEG-1434 6", 8" and 10" Roof Augers

4. Assembly

Installing the Belt Guard

A. With the belts properly tensioned, remove the bottom belt guard cover and slip belt guard down

over the motor shaft.

B. Bolt the belt guard to the belt guard mounting brackets, the brackets should still be loose at this time.

C. Align the motor shaft and the flight drive shaft in the belt guard’s slot, making sure that the belt

guard DOES NOT contact either pulley, and tighten down the belt guard mounting brackets to the
bearing plate.

(See Figure 4Q.)

D. Once the brackets are tightened, slide the bottom cover back into place and secure with

supplied bolt.

Figure 4Q

See also other documents in the category Grain Systems Equipment: