Mounting bearing to bearing plate, Installing bearing plate onto tube – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 User Manual
Page 16
16 PNEG-1434 6", 8" and 10" Roof Augers
4. Assembly
Mounting Bearing to Bearing Plate
A. Align bolt holes on bearing flange with bolt holes on bearing plate.
B. Secure bearing to bearing plate using appropriate bolts, lock washers, and nuts.
and
Figure 4H
Installing Bearing Plate onto Tube
A. Align bearing with drive shaft and slip shaft through bearing.
B. Rotate plate until bolt holes in tube flange and plate align. Secure with appropriate bolts and
serrated flange nuts.
C. Only secure with UPPER and LOWER four (4) bolts.
The other four
(4) bolts will be installed later with the belt guard mounting brackets.
NOTE: On the 10" systems use the four (4) 3/8"-16 x 1" bolts in this step, the longer bolts will be used
to attach the belt guard mounting brackets in a future step.
Bearing Bolts
6"
7/16"-14 x 1-1/2" Hex Bolts
8" and 10"
1/2"-13 x 1-1/2" Hex Bolts
Bearing Plate Bolts
6" and 8"
5/16"-18 x 1" Hex Bolt
10"
3/8"-16 x 1" Hex Bolt
for bolt sizes.)