beautypg.com

Installing the motor mount plate – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 User Manual

Page 18

background image

18 PNEG-1434 6", 8" and 10" Roof Augers

4. Assembly

Installing the Motor Mount Plate

A. Secure one (1) of the motor mount adjustment nuts and one (1) the motor mount adjustment

washers approximately 3/4" of the way down the motor mount adjuster’s threaded shaft.

B. Once the nut and washer is secure, slip the motor mount plate over the adjuster and align the pivot

holes with the pivot tube.

(See Figure 4K.)

C. Slide the motor mount pivot rod through the pivot tube on the discharge tube.

D. When the pivot rod begins to extend through the pivot tube install the spacers, BETWEEN the

back plate and the inner face of the motor mount plate.

(See Figure 4L.)

NOTE: The number of spacers will vary between each size of unloader.

Figure 4K

Figure 4L

See also other documents in the category Grain Systems Equipment: