beautypg.com

Installing the motor mount adjuster, Installing bearing plate onto tube (continued) – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 User Manual

Page 17

background image

4. Assembly

PNEG-1434 6", 8" and 10" Roof Augers

17

Installing Bearing Plate onto Tube (Continued)

Figure 4I

Installing the Motor Mount Adjuster

A. Place motor mount adjuster between the back plate and head plate on the discharge tube.

B. Insert pivot rod through the tube plates and motor mount adjuster. Secure in place with

two (2) 3/16" x 2" cotter pins.

(See Figure 4J.)

Figure 4J

(

See Chart on Page 16

for bolt sizes.)

NOTE: Only the upper and lower four (4) bolts
are connected at this point in the assembly.

See also other documents in the category Grain Systems Equipment: