Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1366 - Manual (Page 26)

5. Assembly
26 PNEG-1366 12" and 16" Series II Sweep Quick Disconnect Control Box Kit
Initial Display Setup
NOTE: If no keys are activated for 2 minutes, the display returns to the default state without saving any
configuration changes. At each value, after 5 seconds of inactivity, a description of the current
state will scroll across the display.
NOTE: Pressing and hold OK will return to the previous menu or return to the default state without saving
the changed values or parameters.
Press OK on the display unit.
(IN) should be displayed on the unit.
Press or on the display unit until (CURR) is shown (not VOLT, POTM, or TEMP).
Press OK.
(RANG) should be displayed on the unit.
Press or on the display unit until 4-20 is shown (not 0-20).
Press OK.
(DEC.P) should be displayed on the unit.
Press or on the display unit until 11.11 is shown (not 1111, 111.1, 1.111 or .1111).
Press OK.
(DI.LO) should be displayed on the unit.
Press or on the display unit until 0 is shown.
Press OK.
(DI.HI) should be displayed on the unit.
The DI.HI value is 2x the value that the FLA dial on the auger drive motor (M2) that was set earlier.
2x FLA Dial: ____
Press or on the display unit until the correct value is shown.
Press OK repeatedly until “-----” is displayed. This indicates the programming described above has
been saved.
Make sure no individual is inside the bin.
Make sure the sweep will not contact any obstruction and cause damage.
Have an employee observe the sweep from outside the bin, through the open door.
The person observing the sweep is meant to have control over the safety foot switch.
Have another employee operate the control panel.
Switch the Run Mode switch so that Manual is selected (not Auto).