Control panel conduit hole (pre-june 2010) – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1366 User Manual

Page 19

Text mode
Original mode

5. Assembly

PNEG-1366 12" and 16" Series II Sweep Quick Disconnect Control Box Kit

Control Panel Conduit Hole (Pre-June 2010)

NOTE: The Series II Sweep has used different control boxes. The quick disconnect kit will fit either style

box. Hardware is provided to mount an older style box (with ears) to the mounting plate. The new
style box already has hardware installed in the rear of the box.

1. Cut a hole into the side panel of the control box in the location shown in

Figure 5B

. Hole to be sized

for 1-1/2" rigid conduit (approximately 1.900"). Make sure all metal chips/shavings are removed from
the inside of the box.

Figure 5B