Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1366 - Manual (Page 22)

5. Assembly
22 PNEG-1366 12" and 16" Series II Sweep Quick Disconnect Control Box Kit
Install each receptacle to the panel with the supplied hardware. Consult the wiring schematic in the panel
enclosure for proper electrical connection locations.
Once the receptacles have been properly installed, the auxiliary guidance handles can be attached to the
panel assembly.
Guidance Handle Installation
Attach handles. Four (4) handles are supplied and can be located in any of the holes on the outside
edges of the back base plate. USE THE CORRECT SIZE SCREWS. (Only two (2) handles shown.)
(See Figure 5F below and Figure 5G on Page 23.)
Figure 5F
Use 1/4"-14 x 1-1/4" screws for handles that attach to the base back plate at the
stiffener bar locations. Use 1/4"-14 x 1" screws for handles that attach at all other
locations. These handles are for guidance only.
See Figure 1A on Page 5 for
lifting instructions.
Using the wrong size screws can cause the threads to strip or not give enough
support and serious injury or death can occur.