beautypg.com

End wheel assembly – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 User Manual

Page 21

background image

4. Assembly

PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions

21

End Wheel Assembly

NOTE: If installing sweep tractor to an existing sweep, the current end wheel components must

be removed.

1. Connect the stub shaft into the sweep flight using a 5/8"-11 x 4" hex head cap screw and

5/8" stover nut.

2. Install the bearing stand assembly onto the stub shaft and bolt it to the sweep shield using two (2)

3/8" x 3" carriage bolts, flat washers and nylock nuts.

3. Install the end wheel and collar onto the end of the stub shaft. Pin the collar in place with a

1/2" x 3-1/2" hex head cap screw and prevailing torque lock nut.

(See Figure 4L.)

Figure 4L End Wheel Assembly

See also other documents in the category Grain Systems Equipment: