beautypg.com

Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 User Manual

Page 20

background image

4. Assembly

20

PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions

21. Mount the weights to the weight stand using one 5/8"-11 x 8-1/2" threaded rod and three (3) flange

nuts and one flat washer.

(See Figure 4K.)

NOTE: Install the weights against the left hand of the weight stand so the weight is in the middle of

the tractor assembly. The weight stand can be reversed so that the weights hang over the
front of the frame, if necessary. Adjust the weights to the inside of the frame to center the
weight on the frame when the weight stand is reversed as described above.

Figure 4K