Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 - Manual (Page 15)

4. Assembly
PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions 15
11. Bolt the four (4) 5/8"-11 x 6" threaded rods to the tractor frame using one 5/8"-11 hex nut for
each rod. (See Figure 4E.)
Figure 4E
12. Place one 5/8"-11 hex nut onto each rod in a temporary position. These will hold the motor plate in
place. (See Figure 4F.)
Figure 4F