beautypg.com

Assembly, Chapter 4 assembly, Sweep tractor assembly – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 User Manual

Page 11

background image

PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions

11

4. Assembly

Sweep Tractor Assembly

1. Place the tractor frame on plain flat ground.

2. Bolt each pillow block bearing to a bearing mount bracket using two (2) 1/2"-13 x 2" hex head

cap screws, two (2) flat washers and serrated flanged nuts.

3. Bolt each bearing mount bracket to the tractor frame using two (2) 1/2"-13 x 1-1/4" flange bolts and

serrated flanged nuts.

(See Figure 4A.)

NOTE: Lock collar flanges for each pillow block bearing must be to the inside of frame.

Figure 4A

See also other documents in the category Grain Systems Equipment: