Grain Systems Bin Accessories PNEG-1802 - Manual (Page 41)

4. Inside Ladder Installation
PNEG-1802 Inside Ladder Instructions 41
Inside Ladder Standoff Bracket/Supports
Inside Ladder Standoff
Bracket Requirements
For the standoff brackets, field drill two (2)
3/8" diameter holes 18-3/4" apart directly in line
with the horizontal seam holes. Continue down
the sidewall with standoff brackets every 16".
Refer to
Figure 4AK .
Figure 4AK
Inside Ladder Supports
After completing the inside ladder, be sure to
support the bottom of the ladder to the concrete.
Depending on the actual installation, the amount
of support required may vary. Supports are not
supplied by the manufacturer. If a bin sweep is to
be used in the grain bin, other considerations may
be necessary to assure there is no interference
with the equipment. Refer to
Figure 4AL .
Figure 4AL