Grain Systems Unload Augers PNEG-1583 - Manual (Page 19)

4. Installation
PNEG-1583 10" Commercial Replacement Drive Kit 19
Install the Motor Mount Adjuster
1. Place the motor mount adjuster between the bottom pivot holes on the motor mount plate.
(See Figure 4P.)
2. Insert the pivot rod through the front bottom pivot hole, the motor mount adjuster, and the back
bottom pivot hole. Secure the pivot rod in place with two (2) 3/16'' x 2'' cotter pins . (See Figure 4P.)
3. With the cotter pins in the pivot rod, bend one tab of the cotter pin back so that it touches the pivot
rod, and bend the other tab of the cotter pin away from the first tab. (See Figure 4Q.)
Figure 4P
Figure 4Q