beautypg.com

Assemble the bearing to the bearing plate – Grain Systems Unload Augers PNEG-1583 User Manual

Page 17

background image

4. Installation

PNEG-1583 10" Commercial Replacement Drive Kit 17

Assemble the Bearing to the Bearing Plate

1. Bolt the previously removed 1-1/2" four (4) hole flange bearing to the bearing plate using

four (4) 1/2'' x 1-1/2'' hex bolts, lock washers and hex nuts.

Figure 4L

Assemble the Bearing Plate Assembly to the Head Plate

1. Slide the bearing plate over the drive shaft and line up the bearing plate assembly in front

of the head plate.

2. Bolt the bearing plate assembly to the head plate using four (4) 3/8'' x 1'' hex bolts and serrated

flange nuts.

Figure 4M

See also other documents in the category Grain Systems Equipment: