Grain Systems Unload Augers PNEG-1583 - Manual (Page 18)

18 PNEG-1583 10" Commercial Replacement Drive Kit
4. Installation
3. Slide the bearing lock collar over the drive shaft up to the bearing. Using a hammer and punch,
continue to drive it onto the bearing in the clockwise direction, the same direction of the auger flight
rotation.
(See Figure 4N.)
4. Tighten the set screw on the lock collar to the drive shaft.
Figure 4N
Assemble Belt Guard Brackets to the Head Plate
1. Place the left and right hand belt guard brackets up to the head plate.
2. Loosely bolt the brackets to the head plate using three (3) 3/8" serrated flange nuts and flat
washers. (See Figure 4O.)
Figure 4O