Rough Country 1132 User Manual
Page 2
INSTALLATION INSTRUCTIONS
1. Install the coil retainer in the coil as shown in Photo 1.
2. Install the lower seat flag nut from the front of the axle as shown in Photo 2.
3. Secure in place with the supplied 1/2” x 1 1/2” bolts, flat washers and lock washers from the top through the coil re-
tainer in coil seat. See Photo 3. Tighten using a 3/4”
wrench.
POST INSTALLATION
• Check all fasteners for proper torque. Re-torque all fasteners after 500 miles and recheck after 1000 miles.
PHOTO 1
PHOTO 2
Also available for the rear of the JK Jeep is a Rear Coil Shim kit to straighten the coils on 4”-6” kits. Part # 1113.
PHOTO 3
See also other documents in the category Rough Country For the car:
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)