Rough Country 609S - Manual (Page 7)

33. Locate the brake line bracket and install using the stock
hardware. Install the stock brake line on the other end of
the bracket using the supplied 1/4” X 1” bolts. See Photo
22. Use caution when moving the brake line to not
kink the metal line.
34. This step will be performed on vehicles equipped with
the optional front transmission skid plate only. One
side at a time, using a 18mm socket remove the bolt that
holds the cross member to the frame in front of the rear
upper control arm. Insert 2 washers to each side supplied
in 1681bag, between the frame and cross member as
shown in Photo 23. This will space the cross member
down enough to allow driveshaft clearance at full flex.
Tighten using the stock bolt. Repeat on opposite side.
35. Reinstall the front tires/wheels using a 19mm deep well socket.
36. If removed, relocate the plastic clips on the brake line to hold ABS Line. See Photo 24.
37. Lower the vehicle to the floor.
38. Proceed to rear installation.
PHOTO 23
INSTALL SPACERS
PHOTO 22
INSTALL BRAKE LINE BRACKET
PHOTO 24
SLIDE BRAKE LINE AND ABS CLIPS