Rough Country 5061 - Manual (Page 2)

INSTRUCTION SHEET
Technical Assistance - (731) 285-9000 Page 2
RECOMMENDED TOOLS
• Pry
Bar
• T55
socket
• Safety
glasses
• Wheel
chocks
• Floor
jack
• Mechanic gloves
• Hammer
• 19mm deep well socket
• Alignment spike
• 22mm deep well socket
• 19mm
wrench
• 22mm
wrench
KIT CONTENTS
INSTALLATION INSTRUCTIONS
1. Lift front of vehicle and place jack stands under front of frame rails.
Remove front wheels.
2. Support front axle assembly with stands. Remove front shackles.
3. Install front brackets. Slide bracket into place (See Photo #1) and
install new ½ x 4 ½” bolt, nut and washers. Final tightening is
done in a later step. It is best that the Jeep have weight on the
suspension when tightening. Do not tighten hardware until
the vehicle is on the ground and has weight on the
suspension.
4. Locate the slotted hole on the Rough Country bracket. The hole
utilizes the stock bumper bolt. The hole on the underside of the
bracket utilizes a stock hole on the front factory bracket. Use the
supplied ½” x 1 ½”
bolt, nut and
washers.
See
Photo #2 & 3
Photo 1
Photo 3 Photo 2