Rough Country 1120 - Manual (Page 2)

6. Remove the stock transmission mount from the transmission using a 15mm socket. See Photo 3.
7. Secure the transmission mount to the bracket as shown in Photo 4 with supplied 7/16” x 1” bolts and lock nuts.
8. Install the mount and bracket to the stock location using the stock hardware. Tighten using a 15mm socket. See
Photo 5.
9. The skid plate has two sets of holes for the transmission mounting bracket. See Photo 6.To identify which set of
holes to use, the skid plate and bracket will need to be trial fit on the vehicle.
9. Align the hole on the frame rail and the holes on the
transmission mounting plate. After noting which set of
holes to use, remove the skid plate and mounting plate
and secure the transmission mounting plate to the skid
plate with the supplied 3/8” x 1” bolts. Tighten using a
9/16” socket / wrench. See Photo 7.
10.Reinstall the skid plate and mounting bracket back on
the frame rail and secure the transmission to the plate
using the factory hardware. See Photo 8.
11.Install the plate on the frame rail with the supplied 1/2” x
1 1/2” bolts / washers See Photo 9.
POST INSTALLATION
• All components must be retightened after 500 miles, and every three thousand miles after installation.
PHOTO 3 PHOTO 4
PHOTO 8
REINSTALL TRANSMISSION HARDWARE
PHOTO 9
PHOTO 5 PHOTO 6
MOUNT TRANSMISSION PLATE TO SKID
PHOTO 7
TIGHTEN HARDWARE