Rough Country 876 - Manual

Nissan Titan Traction Bar Kit
Thank you for choosing Rough Country for all your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the kit contents. Be sure you
have all needed parts and know where they go. Also please review tools needed list and make sure you have needed
tools.
PRODUCT USE INFORMATION
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Rough Country product purchased. Mixing component brands is not recommended.
Rough Country makes no claims
regarding lifting devices and excludes any and all implied claims. We will not be responsible for any product that is al-
tered.
We will be happy to answer any questions concerning the design, function, and correct use of our products by call-
ing our toll free number @ 800-222-7023.
NOTICE TO DEALER AND VEHICLE OWNER
Install the supplied “Warning to Driver” decal installed on the inside of the windshield or on the vehicle’s dash. The decal
should act as a constant reminder for whoever is operating the vehicle of its unique handling characteristics.
9287600
Tools Needed:
Wheel Chocks
Ratchet
1 1/8” socket
15mm Socket
19mm Socket
22mm Socket Torque Specs:
Size Grade 8
1/2” 90 ft/lbs
9/16” 130 ft/lbs
5/8” 175 ft/lb
INSTALLATION INSTRUCTIONS
1. Measure 4 1/8” from the factory hole in frame shown in Photo 1 and mark a line or use a piece of tape.
2. Hold traction bar bracket on the line and transfer both holes over to frame. See Photo 2. Make sure bracket is
straight with frame.
Photo 1 Photo 2
Kit Contents:
2-Axle Brackets
2-Frame Brackets
2-Flag Nuts
2-Traction Bars
1
Bag:
4-Heim Ends
4-Hem Spacers
2-Heim Sleeves
4-1/2” x 1 1/2” Bolts
2-12MM X 55MM Bolts
2-12MM X 75MM Bolts
4-12mm Lock Nuts
Measure from edge to hole back 4 1/8” and mark Place bracket on frame and mark holes