Rough Country 684X - Manual (Page 8)

36. Drill the two holes per side using a 17/64” drill bit. See Photo 24. Be sure to only drill through outside of the frame.
37. Install the frame bracket with the supplied 5/16” self tapping bolts (2 per bracket) using a 1/2” wrench. SeePhoto 25.
38. Install the supplied mounting pin as shown in Photo 26 and tighten using 19mm socket / wrench.
39. Install the new Rough Country coil spring spacer as shown in Photo 27 in the factory location, making sure the coil
is positioned properly in the lower seat, as stock was.
40. Swing the new sway bar link down and secure on the
mounting pin using the supplied quick disconnect pin. See
Photo 28.
41. Using a 21mm socket remove the tie rod end from the
pitman arm. Remove the pitman arm nut using a 33mm
socket.
42. Using a pitman arm puller, remove factory pitman arm.
See Photo 29.
43. Install the new pitman arm with the stock hardware an
using a 33mm socket. See Photo 30. Reinstall the drag
link on the new pitman arm with the stock nut and using a
21mm wrench.
44. Reinstall the front tires/wheels , using a 19mm deep well
socket. Lower the vehicle to the floor.
Photo 25
Tighten 5/16” self tapping bolts
Photo 24
Drill Holes using a 17/64” drill bit
Install mounting pin on the axle
Photo 26 PHOTO 27
Link shown installed on pin
Photo 28
PHOTO 29 PHOTO 30