Rough Country 684X - Manual (Page 10)

13. Install the new coil spring spacer with supplied washer/nut retainer and secure the assembly with supplied 1/2” x 2
3/4” bolt & lock washers through the factory coil mount as shown in Photo 36 & 37.
14. Install the factory coil spring isolator as shown. See Photo 38.
15. Install the supplied rear coil shim as shown in Photo 39.
16. Install the top of the coil back onto the coil seat. When installing the bottom of the coil into the seat rotate the coil
until the pigtail hits the spring stop. Lower vehicle slightly, watching coils to assure they properly seat on top
17. Place the bracket on the factory mount and install the supplied 3/8” x 1” Bolts , washers and Flange lock nuts as
shown in the factory holes. Do not tighten at this time. See Photo 40.
18. Verify the original track bar mounting hole and the hole in the track bar bracket are aligned vertically. Using the track
bar bracket as a template mark and drill a 13/32” hole in the top of the original track bar mount from the top.
19. Install using the .375-16 x 1” bolt, washer through the drilled hole from the top and secure with flange nut using a
9/16” wrench and socket. Do not tighten at this time. See PHOTO 41.
Photo 36 Photo 37
Photo 38 PHOTO 39
PHOTO 40 PHOTO 41
Install the rear
track rod
bracket on the
axle
Install the 3/8” x 1” bolt in bracket