Rough Country 1093 User Manual
Page 2
Post Installation
1. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine
vehicle service.
3. Using the 15mm socket install the bump stop cup back onto the bump stop mount using the supplied 10mm
x 80mm bolt. See Photo 3.
4. Reinstall factory bump stop into cup.
5. Reinstall the factory coil spring. See Photo 4.
6. Using the17mm-wrench and 17mm socket, replace the lower sway bar bolt.
7. Install the rear shocks at this time using the factory hardware.
8. Reinstall the rear tires/wheels
9. Lower the vehicle to the ground.
Photo 3
Photo 4
KIT CONTENTS
See also other documents in the category Rough Country For the car:
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)