Rough Country 1157 - Manual (Page 2)

BODY LIFT INSTALLATION INSTRUCTIONS
1. Make sure the vehicle is on a level smooth surface.
2. Loosen the 11 body bolts using a 5/8” socket. Do not remove the stock bolts at this time.
3. Remove the front body mount bolt as shown in Photo 1. Remove either the 5 passenger side bolts or the 5 driver
side bolts. Do not remove both sides. Installation is performed one side at a time.
4. Using a floor jack slowly jack up the body of the Jeep and insert the supplied body lift blocks between the body
and the three side cab mount bushings as shown in Photo 2. Take caution to keep your hands out from between
the frame and the body. The three side body mounts will be secured with the supplied 1/2” x 4 1/2” bolts. Apply
thread locker to the bolts and install. Do not tighten at this time.
5. Insert the supplied body lift blocks in the 4 rear most mounts. Apply thread locker to the supplied 7/16” x 4” bolts
and install. Photo 3 shows all body mounts. Rear corner mount shown in Photo 4. Do not tighten at this time.
6. Place the new radiator core support bracket in place and mark hole to be drilled. See Photo 5.
7. Drill the hole using a 9/32” drill bit. See Photo 6.
8. Secure using the bracket to the frame with the supplied 5/16” x 1” self tapping bolt. Tighten using a 1/2” wrench.
Photo 1 Photo 2
Photo 4
Photo 5 Photo 6
Photo 3