Rough Country 294.20 - Manual (Page 20)

13. The other ground wire is on passenger side body mount behind the tire.
See Photo 13.
14. Remove the O2 sensor wire clip from frame just above passenger side body mount. On driver side remove the wir-
ing loom bracket using a 13mm socket.
See Photo 14. Remove the wire clips from the top of strut bolts.
15. Measure the emergency brake cable adjustment bolt from back of nut to the end of threads and record this measure-
ment for later use. ( Should be about 2.5 ” ). See Photo 15.
16. Then adjust bolt to allow slack so the brake cable can be disconnected. Then release the metal clips holding the
emergency cable to frame on body mount.
See Photo 16.
17. Loosen the front body mount bolts using a 18mm socket and a 21mm on the other body mount bolts.
See Photo 17.
Remove the nuts from the body bushing using a 15mm socket.
See Photo 18. Only remove the bolt on one side at a
time. Lift the body off of frame just enough to remove body bushing. Look an make sure no other wires or brake lines
are being stretched. Front body mount bolt must come out from the top.
PHOTO 15
PHOTO 13 PHOTO 14
PHOTO 16
PHOTO 17 PHOTO 18