Rough Country 294.20 - Manual (Page 18)

1. Disconnect battery using a10mm socket
2. Using a screwdriver disconnect the air filter inlet hose from air box.
See Photo 1. Lock the steering wheel and mark
upper and lower steering shaft. Remove steering shaft from rack and pinion using a 11mm socket.
3. Remove the ten plastic clips from the radiator bezel using a screwdriver.
See Photo 2.
4. Remove the painted bumper bezel from truck using a 7mm socket, remove the two bolts on both side.
See Photo 3.
5. Unclip the painted bumper bezel from the grill. There are six clips behind the bumper. Pull the sides of bumper bezel
out then pull back to remove.
See Photo 4. This may take two people .
6. Remove the 8 bolts holding the front grill on using a 10mm socket. There are 4 bolts on top
See Photo 5 and 4 bolts
on bottom
See Photo 6 of the grill. There are two clips on each side. Pull straight out to release clips
FRONT INSTALLATION INSTRUCTIONS
PHOTO 6 PHOTO 5
PHOTO 3
PHOTO 2
PHOTO 4
PHOTO 1