Rough Country 750S - Manual (Page 4)

POST INSTALLATION INSTRUCTIONS
Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile, fixed and
heated members. Check steering gear for interference and proper working order. Test brake system.
Perform steering sweep. Check to ensure brake hoses have sufficient slack and will not contact rotating, mobile, or fixed
members, adjust lines/brackets to eliminate interference and maintain proper working order. Failure to perform inspections
may result in component failure.
Bump stops and extensions must be in place on all vehicles! Note: allowing suspension to over extend by neglecting to in-
stall or maintain stops and extensions may cause serious damage to OE and related components.
Visually inspect components and re torque fasteners during routine vehicle service.
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 100 miles and then every
1000 miles. Wheel alignment steering system, suspension and driveline systems must be inspected by a qualified
professional mechanic at least every 3000 miles.