Rough Country 261.22 - Manual (Page 6)

28. The brake shroud must be trimmed to allow the caliper to
reinstalled, Mark the dust shroud as shown in Photo 19 and
trim. Reinstall the brake caliper on the knuckle with the
factory hardware and tighten.
29. Remove the brake line bracket from the upper control arm
mount as shown in Photo 20 using a 13mm wrench.
30. Install the supplied brake line relocation bracket on the
upper control arm mount with the stock hardware. Slightly
pull down on the brake line assembly and reinstall on the
drop bracket with the supplied 5/16” x 3/4” bolts, nuts /
washers using a 7/16 wrench. See Photo 21. Reconnect
the ABS wire that was disconnected in Step 6.
31. Remove the brake line clip from the brake line using a flat head screw driver as shown in Photo 22 and trim as shown
in Photo 23 Reinstall the modified bracket on the stock control arm with the stock hardware.
32. If the optional kicker bars were purchased with this kit, install at this time per the instructions included with that kit.
33. Reinstall the factory upper skid plate with the factory hardware.
34. Install the tires and wheels. Jack up the front of the vehicle and remove the jack stands.
35. Lower the vehicle to the ground.
Photo 19
Photo 21
Photo 22 Photo 23
Photo 20